The plumbing is one of those systems in the home that a lot of people take for granted. With all the pipes and plumbing out of sight (and out of mind), it’s easy not to think about them until they begin to show signs of trouble. These problems can range from simple drips from a leaky faucet to frustratingly slow water flow or drainage, and can even extend to a potentially catastrophic gas leak.
Our professionals at Efficient Systems, one of the leading plumbing, heating and air conditioning companies in the area, have listed five of the most common plumbing problems and the steps you should take to fully address them.
One leaky faucet wastes approximately 3,000 gallons of clean water every year. The most common reason for leakage is aging. Older units inevitably leak, so when this happens, the best solution is to have them replaced.
Water Heater Problems
Through our experience as one of the most trusted plumbing, heating and air conditioning companies in Indiana, we’ve found that water heaters suffer from occasional leaks as well. Typically problems with heating pipes are most often caused by mineral deposits. Over time, naturally occurring minerals in the water precipitate and accumulate within the pipes. This issue is particularly complex and should only be handled by a professional.
Clogs can be either partial or complete, and are typically fixed by a plumber. Organic debris such as food particles lodged inside the kitchen sink drain can generally be easily cleared away with drain cleaner, but a full clog caused by insoluble materials like those in toilets usually require the attention of a plumber.
Like leaky faucets, running toilets are a constant drain on your water bill. The most common cause of this problem is the toilet flapper. This rubber cap is lifted when the flush handle is pushed down, allowing the tank to fill until it reaches certain level, at which point the flapper drops back into position. Sometimes, regular use can move the flapper out of position, causing your toilet to continuously run but not fill up. To resolve this issue, lift the tank cover and replace the flapper properly.
Low pressure can be caused by a number of factors, but is most often connected to breaks within your pipework. This can cause leaks that increase your water bill and cause the water pressure in your home to drop at the same time. For problems with pressure, you should always trust the professionals for a solution.
Taking Care of Your Plumbing
At Efficient Systems, we’re one of the leading plumbing, heating and air conditioning companies in the area. Give us a call at (317) 759-5562 or fill out our contact form to request that one of our specialists call you back.